How to Guide

ManualsBrandsCERTIFIED APPLIANCE ACCESSORIES ManualsPlumbing4 ft. PVC Ice Maker Connector

Your Appliance Connection Solution

Ice Maker

CONNECTOR

Certiﬁed Appliance Accessories® polyester-reinforced PVC Ice Maker Connector

is for use as a water supply line on household ice makers.

IMPORTANT: Be sure supply valve IS “OFF” when machine is not in use.

• Inspect hoses regularly for leaks, and every six months thereafter.

• Hoses should be replaced when moving appliance to new location.

• If sharp bend or kink appears in hose, do not use.

• Hose should never be pulled or stretched.

To Install:

1. Turn o water supply at shuto valve.

2. Remove old supply connector from the shuto valve and from

the back of the refrigerator.

3. Connect the PVC ice maker connector to the connector on the

shuto valve on one end and to the connector inlet on the

back of the refrigerator on the other end. Hand-tighten both

connectors plus 1/4 turn with a wrench. Do not overtighten.

4. Slowly turn on the water at the shuto valve to full open

position.

5. Check for leaks.

Note: Certiﬁed Appliance Accessories® recommends installation of this

product be performed by a licensed professional. Connectors

should be replaced every ﬁve years.

IMPORTANTE: Asegúrate de que la válvula de suministro estén cerradas

(“OFF”) cuando la máquina no esté en uso.

• Revisa las mangueras con regularidad para detectar fugas o grietas.

Reemplaza según sea necesario.

• Las mangueras deben cambiarse al trasladar el eqipo a una nueva ubicación.

• Si la manguera tiene algún doblez pronunciado, no la uses.

• Nunca debe halarse o estirarse la manguera.

Para Instalar:

1. Cierre el suministro de agua en la válvula de cierre.

2. Retire el conector de suministro viejo de la válvula de cierre y de la parte posterior del refrigerador.

3. Conecte el nuevo conector de manguera de acero inoxidable al conector de la válvula de cierre en un

extremo y a la entrada del conector en la parte posterior del refrigerador en el otro extremo. Apriete a

mano ambos conectores más 1/4 de vuelta con una llave. No apriete demasiado.

4. Lentamente abra el agua en la válvula de cierre hasta que esté posición completamente abierta.

5. Verique que no haya fugas.

Nota: Certiﬁed Appliance Accessories® recomienda la instalación de este producto sea realizado por un

profesional autorizado. Las mangueras debea reemplazarse cada cinco años.

SHUTOFF

VALVE

BACK OF REFRIGERATOR

REMOVE OLD HOSE

BACK OF REFRIGERATOR

SHUTOFF

VALVE

INSTALL NEW HOSE

SHUTOFF

VALVE

TIGHTEN NEW HOSE

SHUTOFF

VALVE

TURN OFF

WATER

Summary of content (1 pages)

PAGE 1
Ice Maker CONNECTOR Your Appliance Connection Solution® Certified Appliance Accessories® polyester-reinforced PVC Ice Maker Connector is for use as a water supply line on household ice makers. IMPORTANT: Be sure supply valve IS “OFF” when machine is not in use. • Inspect hoses regularly for leaks, and every six months thereafter. • Hoses should be replaced when moving appliance to new location. • If sharp bend or kink appears in hose, do not use. • Hose should never be pulled or stretched.