User's Manual
Table Of Contents
- FCC Statements
- Notes/Definitions
- Document Conventions
- Table of Contents
- List of Figures
- List of Tables
- Cervis Inc. Safety Precautions
- 1.0 SmaRT HH-xH06 Handheld Remotes
- 2.0 Associate Handheld to Base Unit
- 3.0 Dissociate Handheld from Base Unit
- 4.0 Battery Installation or Change
- 5.0 Using a Standard SmaRT Handheld Remote
- 6.0 Low Battery and Low Battery Auto-Shutdown
- 7.0 Specifications
- 8.0 Spare Parts List
- Appendix A: HH-x06 Product Variation List
- Appendix B: Exposure to Radio Frequency Energy
- Appendix C: Agency Identification Label Locations
Handheld Remotes Manual
2013 Cervis, Inc.
7
4.0 Battery Installation or Change
SmaRT HH-xH06 handheld units are powered by three size AAA alkaline batteries. When
installing batteries, be sure to observe proper polarity as marked on the inside of the
compartment to avoid damaging the unit. To replace or install batteries in the handheld:
1. Remove the four small Phillips screws from the Battery Compartment cover and
lift the cover from the handheld.
2. If installing batteries in an empty battery compartment, install three fresh size
AAA batteries. Be sure to position the batteries as shown in Figure 4 below.
3. If replacing expired batteries, remove the old batteries and install three fresh size
AAA batteries. Be sure to position the batteries as shown in Figure 4 below.
4. Replace the compartment cover and tighten the four Phillips screws. These
screws should not be over-tightened, but they should be tight enough to assure
the gasket provides a proper seal.
Figure 4. Handheld Battery Installation
Note: Cover screws must be tightened enough to ensure the sealing gasket is compressed.
Do not over-tighten the screws.
Be sure to observe proper polarity when placing batteries in the
handheld battery compartment.
Sealing gasket
Cover
screw