User's Manual
Table Of Contents
- FCC Statements
- Notes/Definitions
- Document Conventions
- Table of Contents
- List of Figures
- List of Tables
- Cervis Inc. Safety Precautions
- 1.0 SmaRT HH-xH06 Handheld Remotes
- 2.0 Associate Handheld to Base Unit
- 3.0 Dissociate Handheld from Base Unit
- 4.0 Battery Installation or Change
- 5.0 Using a Standard SmaRT Handheld Remote
- 6.0 Low Battery and Low Battery Auto-Shutdown
- 7.0 Specifications
- 8.0 Spare Parts List
- Appendix A: HH-x06 Product Variation List
- Appendix B: Exposure to Radio Frequency Energy
- Appendix C: Agency Identification Label Locations
Handheld Remotes Manual
Cervis Inc. Safety Precautions
Read and follow all instructions.
Failure to abide by Safety Precautions may result in equipment failure, loss of
authority to operate the equipment, and personal injury.
Use and maintain proper wiring. Follow equipment manufacturer instructions.
Improper, loose, and frayed wiring can cause system failure, equipment damage, and
intermittent operation.
Changes or modifications made to equipment not expressly approved by the
manufacturer will void the warranty.
Owner/operators of the equipment must abide by all applicable Federal, State, and
Local laws concerning installation and operation of the equipment. Failure to comply
could result in penalties and could void user authority to operate the equipment.
Make sure that the machinery and surrounding area is clear before operating. Do not
activate the remote control system until certain that it is safe to do so.
Turn off the handheld remote and remove power from the base unit before attempting
any maintenance. This will prevent accidental operation of the controlled machinery.
Power can be removed from the handheld remote by removing the source power
(batteries) from the circuit.
Power can be removed from the Base Unit by removing the source power from the
circuit.
Use a damp cloth to keep units clean. Remove mud, concrete, dirt, etc. after use to
prevent obstructing or clogging the buttons, levers, wiring, and switches.
Do not allow liquid to enter the handheld or base unit enclosures. Do not use high
pressure equipment to clean the handheld remote or base unit.
Disconnect the radio base unit before welding on the machine. Failure to disconnect
the base unit may result in destruction of or damage to the base unit.
Operate and store units only within the specified operation and storage temperatures
defined in Specifications of this document.