User's Manual

Handheld Remotes Manual

2013 Cervis, Inc.

2.0 Associate Handheld to Base Unit

Each SmaRT handheld must first establish a communication link with the base unit before the

base unit will recognize the handheld unit. This process is called Associate and it applies to all

HH-xH06 handhelds. A handheld remote as part of a system is associated to the system base

unit before leaving Cervis. In situations where it is necessary to re-establish handheld to base

unit communications, the following steps are used:

1. Remove power from the base unit and turn off (PTO – time out) the hand-held device.

2. Stand near the base unit in unobstructed, clear line-of-sight with the handheld in hand.

3. Simultaneously press and hold the Associate (B1) and Dissociate (B2) buttons. RX and ER

light.

4. Continue to hold both buttons until TX and RX light steady.

5. When TX and RX light, release B1 and B2. ER and BA light.



Note: If the next button press is not immediately performed (approximately 2sec.), all LEDs

flash and the Associate procedure is aborted. The process must be started anew to establish

the communication link.

6. Immediately press and hold the Associate button (B1). All LEDs light.

7. TX begins to slowly blink. Continue to hold B1.

8. Apply power to the base unit.

The handheld and base unit begin to establish a communication link while the Associate button

is held. Once the process is complete, all LEDs light briefly and then go out.

9. Release the Associate button.

The SmaRT System is ready for use with that particular handheld remote.

Figure 3. Handheld Buttons

ASSOCIATE

DISSOCIATE