User's Manual

SmaRT 206
U024.2-SmaRT_206_SYS-R
4
1.4 Handheld ↔ Base Unit Communication
A standard SmaRT 206 System comes with one PTO-206 Handheld Remote and one
BU-206F Base Unit, but each BU-206F is capable of communicating with up to eight
PTO-206 Handheld Remotes. Each handheld must first establish a communications link
with the base unit before the base unit will recognize the handheld unit. This process is
called Association.
1.4.1 Handheld ↔ Base Unit Association
Handheld ↔ Base Unit Association is established using the following steps:
1. Remove power from the base unit.
2. Stand near the base unit in line of sight with the handheld in your hand.
3. Simultaneously press and hold the Association and Disassociation
buttons (see Figure 5). The TX LED glows steady green.
Figure 5. Handheld PTO Front Panel
4. Continue to hold both buttons for the five seconds it takes for the LINK
LED to begin flashing amber.
5. When the LINK LED flashes amber, release the two buttons. The RX LED
flashes red allowing two (2) seconds for you to make the next button
press.
 Note: If the next button press is not performed within the two second interval that RX
flashes red, the Association procedure is aborted and must be started anew to
establish the communication link.
ASSOCIATE to
base unit.
DISASSOCIATE
from base unit.
Output ID
(writable, 1 per
button)
Base
Unit
Output
Control
TX
Flashes
Green while
transmitting
RX
Flashes Red
while receiving
Amber while
linking
2
1
4
3
6
5