User's Manual

900MHz Base Unit Manual
Cervis Inc. Safety Precautions
 Read and follow all instructions.
 Failure to abide by Safety Precautions may result in equipment failure, loss of
authority to operate the equipment, and personal injury.
 Use and maintain proper wiring. Follow equipment manufacturer instructions.
Improper, loose, and frayed wiring can cause system failure, equipment damage, and
intermittent operation.
 Changes or modifications made to equipment not expressly approved by the
manufacturer will void the warranty.
 Owner/operators of the equipment must abide by all applicable Federal, State, and
Local laws concerning installation and operation of the equipment. Failure to comply
could result in penalties and could void user authority to operate the equipment.
 Make sure that the machinery and surrounding area is clear before operating. Do not
activate the remote control system until certain that it is safe to do so.
 Turn off the handheld remote and remove power from the base unit before attempting
any maintenance. This will prevent accidental operation of the controlled machinery.
 Power is removed from the Base Unit by detaching the 12-pin cable from the base unit
connector P1 and P2, or by removing the source power from the circuit.
 Use a damp cloth to keep units clean. Remove mud, concrete, dirt, etc. after use to
prevent obstructing or clogging the buttons, levers, wiring, and switches.
 Do not intentionally allow liquid to enter the handheld or base unit enclosures. Do not
use high pressure equipment to clean the handheld remote or base unit.
 Disconnect the radio base unit before welding on the machine. Failure to disconnect
the base unit may result in destruction of or damage to the base unit.
 Operate and store units only within the specified operation and storage temperatures
defined in this document.
Push-To-Operate means that the outputs under control should only change states
when the appropriate button or switch of the remote is pressed or positioned, and
then only for the duration of time that particular output button is pressed. Any
unexpected motion that occurs when pressing the output control buttons of a
remote must be investigated.
Immediately stop operation should a jerkiness of motion occur while constantly
pressing an output control. Check the base unit diagnostic LEDs for any indication
of a problem.
Be aware that even if the diagnostic LEDs of the handheld remote and base unit do
not indicate a problem, one may be present and further troubleshooting steps may
be needed.
If the problem is found, do not operate the SmaRT System until the problem is
resolved.