Installation manual

TM70/3-10 & i-Kontrol Console RC System
U035.3-TM70_Console_Sys
2
1.1 What You MUST Do

Strictly adhere to the installation instructions contained in this manual.

Make sure that professional and competent personnel carry out the installation.

Make sure that all site and prevailing safety regulations are fully followed.

Make sure that this manual is permanently available to the operator and maintenance
personnel.

Keep the transmitter out of reach of unauthorized personnel.

Remove the transmission key when the transmitter is not in use.

At the beginning of each work day, check to make sure that the Stop Button and other
safety measures are working.

When in doubt, press the Stop Button.

Whenever several systems have been installed, make sure the transmitter you are
about to use is the right one. Identify the machine controlled by the transmitter on the
transmitter label (customer supplied).

An audible or visual warning device indicating the machine is electrically active and
that the transmitter has control should be installed on the machine.

Service the equipment periodically.

When carrying out repairs, only use parts supplied by Cervis dealers.
1.2 What You MUST NOT Do

Never make changes to the system that have not been studied and approved by
Cervis.

Never power the equipment with anything other than with the specified power supply.

Never allow unqualified personnel to operate the equipment.

Never leave the equipment ON after use. Always use the ON/OFF Key or the Stop
Button to avoid accidental movements.

Never use the system when visibility is limited.

Never abuse the transmitter. Avoid dropping.

Never use the system if failure is detected.