Installation manual

Operation and Installation Manual
2013 Cervis, Inc.
21
12.0 Change Base Channel
Console box transmitters using software version V2.4 and above can more easily change the
base channel than previous versions. The is done as follows:
1. Recognize that a switch (Figure 11), lever, joystick, etc. marked with a triangle and a square
are used to change base unit channel Tens and Units. The ▲ allows base channel tens to
be changed, and the ■ symbol position allows base channel units to be changed.
Figure 11. Change Base Channel Assignment
2. Turn the transmitter ON and release the STOP button.
3. Press and hold the ▲ and then press the START pushbutton.
4. Although the Active status is signalled (red LED blinking and buzzer active), continue to wait
until the LED is constantly lit ORANGE.
5. The LED will then indicate the base channel using RED and GREEN pulses.
• The number of GREEN pulses indicates the number of Tens where 5 GREEN pulses
equals 50.
• The number of RED pulses indicates the number of Units, where 5 RED pulses equals 5.
6. The LED will then light steady ORANGE.
7. Press the switch, button, etc. toward the ■ (Base Channel Units) the number of times
needed to register the new Base Channel unit number desired. For instance, for 2 you would
work the toggle UP two times to equal 2.
Press the switch ▲ ( Base Channel Tens) the number of times needed to register the
number of tens needed. For instance, for 2 you would work the toggle two time to equal 20.
After Saving (Step 7), the combined effort will yield a desired Base Channel 22 that will
flash-display on the LED as two GREEN and two RED when ▲ and START is pressed and
held under normal operation.
8. Press and hold the START button. The unit will go through a series of flashes, but continue
to hold the START button unit the LED lights steady Orange (Amber); this saves the
changes.
9. Press the STOP button to exit the procedure.
Unit Increment
Tens Increment