Installation manual

TM70/3-10 & i-Kontrol Console RC System
U035.3-TM70_Console_Sys
38
14.6 Available Icons
Icons available for display are:
• Battery: 43h direction. This icon is composed by four other icons:
 Battery cover
 Left cell
 Central cell
 Right cell
• NEW: 2h direction. This will appear if the level is other than zero
14.7 VT100 Display Control
14.7.1 Control Characters
LDC70 recognized control characters are:
• ESC (1Bh): Control character that initializes a control sequence.
• NUL (00h): Ignored on input (not stored in the input buffer).
All other control characters cause no action to be taken
14.7.2 Valid Control Sequences
Definitions:
The following defines the basic elements of the ANSI mode control sequences.
1. VT100 Control Sequence Introducer (CSI): ESC [
2. Parameter string: A string of parameters separated by a semicolon (3Bh).
3. Final character: a character whose bit combination terminates an escape or control
sequence (‘m’, 6Dh).
Control Sequences
•
ESC [ 0 (1Bh 5Bh 30h): Control sequence to turn off all character attributes (‘0’ is the
optional, default value)
• ESC [Pn ; Pn H (1Bh 5Bh line 3Bh column 48h): moves the active position of the cursor to
the position specified by the parameters. The default condition with no parameters present
is equivalent to a cursor to home action. Lines are numbered consecutively, with the origin
being line 1, column 1. The cursor is not allowed to be positioned outside the margins
(lines 1 to 4, columns 1 to 12). A sequence with one Pn numeric parameter with a default
(0) parameter will be interpreted as wrong sequence. Example: ESC [ 2 ; 0 H or ESC [ 2 ;
H are wrong sequences!
• ESC [ 2 J (1Bh 5Bh 32h 4Ah): all lines are erased, and the cursor does not move
• ESC [ 4 (1Bh 5Bh 34h): All following characters transmitted are underscored until receiving
an escape sequence ESC [ 0 m
• ESC [ 5 (1Bh 5Bh 35h): All following characters transmitted are blink until receiving an
escape sequence ESC [ 0 m
• ESC [ 7 1Bh 5Bh 37h): All following characters transmitted are negative (reverse) image
until receiving an escape sequence ESC [ 0 m
All other control sequences or wrong sequences cause no action to be taken.
Example