Installation manual

TM70/3-10 & i-Kontrol Console RC System
U035.3-TM70_Console_Sys
54
17.1 Single Master Transmitter Systems
Figure 31. Single Master Transmitter System
The Master Transmitter crane selector has options 1/1+2/2.The Slave Transmitter only has an R
release pushbutton.
When Tandem Operation Is Needed (Figure 31)
1. The operator of the Master Transmitter must have the Slave Transmitter operator RELEASE
Receiver 1. To release, the R pushbutton and the START button must by simultaneously
pressed. Transmitter 1 commands Receiver 1 to disconnect and ready itself to accept a new
ID code.
2. The operator of the Master Transmitter then selects Switch Position 1+2.
3. The operator of the Master Transmitter must press and hold the START button until the
Green LED switches ON. This commands Receiver 2 to release Receiver 2, and then new ID
codes are sent to both Receiver 1 and Receiver 2.
Both receivers 1 and 2 are then started, ready for tandem operation.
When Tandem Operation Is Finished
When tandem operation has finished, the Master Transmitter must select Switch Position 2
again (in our example above) and press the Start button. Receiver 1 is release again ready to be
used by the Slave Transmitter, and the Master Transmitter then only controls Receiver 2.
 Note: To reconnect Transmitter 1 to Receiver 1 in our example above, the operator must first
cycle the transmitter — power it OFF and then ON — and then press the START button
while the selector switch in set to 1.
F2
F2
F1
F2
F2
ID1
ID2
ID2
F1
ID1
ID2
SLAVE
RECEIVER 1
RECEIVER 2
MASTER
SLAVE