Installation manual

Operation and Installation Manual
2013 Cervis, Inc.
55
17.2 Two Master Transmitter Systems
Figure 32.Two Master Transmitters System
In Two Master Transmitter Systems, each transmitter will have a 1/1+2/2 Selector Switch and
an R (release) Pushbutton.
When Tandem Operation Is Needed (Figure 32)
In the following example, Master II is going to become the tandem operator for Receiver 1 and
Receiver 2.
1. Transmitter Master 1 operator must simultaneously press the R (release) and START
buttons. This frees Receiver 1.
2. Transmitter Master 2 operator sets the selector switch to 1 & 2.
3. Transmitter Master 2 operator presses and holds the START button until the Green LED
switches ON. This commands Receiver 2 to release Receiver 2, and then new ID codes are
sent to both Receiver 1 and Receiver 2.
Both receivers 1 and 2 are then started, ready for tandem operation.
When Tandem Operation Is Finished
When tandem operation has finished, the Master Transmitter must select Switch Position 2
again (in our example above) and press the Start button. Receiver 1 is release again ready to be
used by the Slave Transmitter to reconnect. The Master Transmitter then only controls Receiver
2.
 Note: To reconnect Transmitter 1 to Receiver 1 in our example above, the operator must first
cycle the transmitter — power it OFF and then ON — and then press the START button while
the selector switch in set to 1.
F1
F1
F2
F2
ID1
ID2
ID1
ID2
ID1
ID2
F1
F2
F1
F2
MASTER I
MASTER II
RECEIVER 1
RECEIVER 2