Installation manual

User Whatever v1.00
Cervis Inc. Safety Precautions

Read and follow all instructions.

Failure to abide by Safety Precautions may result in equipment failure, loss of
authority to operate the equipment, and personal injury.

Use and maintain proper wiring. Follow equipment manufacturer instructions.
Improper, loose, and frayed wiring can cause system failure, equipment damage, and
intermittent operation.

Changes or modifications made to equipment not expressly approved by the
manufacturer will void the warranty.

Owner/operators of the equipment must abide by all applicable Federal, State, and
Local laws concerning installation and operation of the equipment. Failure to comply
could result in penalties and could void user authority to operate the equipment.

Make sure that the machinery and surrounding area is clear before operating. Do not
activate the remote control system until certain that it is safe to do so.

Turn off the handheld remote and remove power from the base unit before attempting
any maintenance. This will prevent accidental operation of the controlled machinery.

Use a damp cloth to keep units clean. Remove mud, concrete, dirt, etc. after use to
prevent obstructing or clogging the buttons, levers, wiring, and switches.

Do not allow liquid to enter the handheld or receiver enclosures. Do not use high
pressure equipment to clean the handheld remote or receivert.

Disconnect the receiver before welding on the machine. Failure to disconnect the
receiver may result in destruction of or damage to the unit.
These instructions must be read carefully in order to install and use
the system properly, to keep it in safe working condition, and to
reduce the risks of misuse.
Do not use this system in potentially explosive atmospheres.
Any use other than that specified in this manual is DANGEROUS.
Strict adherence to the following instructions is a MUST.
 Note: To comply with FCC RF exposure compliance requirements, this device and its
antenna must not be co-located or operating in conjunction with any other antenna or
transmitter.