Specifications
CES SUPPORT 407-679-9440 Page 15 MAN71© CES 1996
Repeat Audio (46#)
This allows receive audio to be repeated and transmitted for mobile to mobile communications. This feature is only
available in half duplex mode.
0 = off 1 = on
Example: To enable the repeat audio function enter the following sequence: 46# 1#
Courtesy [roger] Beep (47#)
The 4700 provides a short audible courtesy beep to the telephone line each time the mobile user unkeys. This gives
an audible indication to the telephone party that they may now begin to talk.
0 = off 1 = On
Example : To enable courtesy beep function enter the following sequence: 47# 1#
Toll Restriction on speed dial location (48#)
Speed call locations can be toll restricted by enabling this command. When enabled, this will prevent dialing of
digits entered in the toll restrict locations.
0 = no 1 = yes
Example: To disable this feature enter the following sequence: 48# 0#
CW ID Interval (49#)
The CW ID feature can be programmed to transmit the Station Identification at pre-programmed CWID Time
Interval, connect, connect & interval time, disconnect, interval time & disconnect, connect /disconnect, interval time
& connect / disconnect, or it may be disabled. The CW ID will not be transmitted if the system is busy.
0 = off 1 = timer 2 = connect 3 = timer & connect 4 = disconnect
5 = timer & disconnect 6 = connect/disconnect 7 = timer, connect/disconnect
Mode of Operation (50#)
The model 4700VP can operate in three different modes; Half Duplex, Simplex Sampling or Simplex with
VeraTecâ„¢ Smart Sampling.
Half Duplex
In Half Duplex the 4700VP will keep the transmitter keyed for the duration of the call. When programmed for half
duplex operation it must be installed on a repeater or two radios using different frequencies.
Simplex Sampling
In the Simplex Sampling mode the 4700VP will sample at the programmed rate looking for a mobile carrier. If there
is a carrier present it will stay in the receive mode until carrier goes away. If the carrier is not present, the 4700VP
will go back to transmit mode until the next sample interval.