User manual

The GPS-206 should be used as a template to mark screw holes for installation. The mounting holes are

designed for a number 8 screw.

3.2 Installing Cables

To ensure proper operation of the GPS-206 please follow these precautions:

• Remove power from the GPS-206.

• Do not create sharp bends, loops or crimps in the cables.

• Attach all cables to the vehicle and equipment in such a way as to reduce stress or wear caused by

the vibration generated by moving vehicles.

• No more than a combined total of ten (10) pounds force can be applied to the GPS-206

connectors.

• Properly terminate all power cables.

3.2.1 HRNS057 - 8-Pin I/O Connector

HRNS057 is an 8-pin external I/O connector and cable. This connector provides power and can be used to

interface the GPS-206 with other devices. (Note crimp tool needed and pins – part number).

CES Wireless Technologies can also provide optional cables with connectors. The part numbers vary with

the cable’s intended use. Please contact your CES Wireless Technologies sales or support executive for

more information.

You may also build your own cable. Table 1 describes the functionality of this 8-pin connector. CES

recommends using 20-gauge wire when building the connector. Pins that are not planned for usage should

be left open without anything connected to them.

Pin Number Functionality HRNS057 Color Codes

1 Switched Power (Ignition) White

2 Serial Data In (RS232) No Connection

3 Serial Data Out (RS232) Co Connection

4 Ground Black

5 Unswitched Power (Battery) Red

6 Input 1 Blue

7 Input 2 Green

8 Output 1 (Default state is High) Brown

Table 1: 8-pin I/O Connector Functionality

The following figure shows the pin connections for the 8-pin connector.