User manual

Appendix 3 – Configuration Form

Revision 1.0. May 5, 2011

Cellular Carrier Information

Select the cellular carrier from the list of carriers whose programming information is known to CES.

Otherwise, enter the required information. If purchasing cellular service from CES no entry is required.

Carriers

AT&T (Cingular)

Required information if the cellular carrier is not in the list above.

APN:

User Name:

Password:

Gateway Number (for SMS):

Server Information

If not using FleetLinc the following information is required.

The Server must have a static IP Address. The Port used must be routed correctly through the

firewall/router and the server must also have this port open.

Server’s Static IP Address

Port (UDP)

Position Reporting

Position reporting intervals are determined by the values of 3 parameters. These are Minimum Time,

Maximum Time and Distance. The default programming is to send position every 5 minutes when the

vehicle has moved 1000 feet and to send every hour when it is idle.

If fixed time interval reporting is desired all that is required is the minimum time interval. Please note that

sending position uses data and if this done too frequently it is quite possible that there will be data usage

overages. These can get quite costly.

Use Fixed Time Interval position reporting. Time interval:

Report more frequently while moving and less while idle or parked. Moving time interval: ,

Idle time interval: , Distance required for movement: .

Our default values for these parameters are as follows. These parameters were calculated from reviewing

the usage patterns of hundred of companies and thousands of mobile devices.

Fixed Interval 5 minutes

Report more frequently while moving 1 minute while moving

60 minutes while idle

1000 feet (~305 meters) required for movement