User manual

3.2.1 HRNS057 -

8-Pin I/O Connector

HRNS057 is an 8-pin external I/O connector and cable. This connector provides power and can be used to

interface the GPS-201/202 with other devices.

CES Wireless Technologies can also provide optional cables with connectors. The part numbers vary with

the cable’s intended use. Please contact your CES Wireless Technologies sales or support executive for

more information.

You may also build your own cable. Table 1 describes the functionality of this 8-pin connector. CES

recommends using 20-gauge wire when building the connector. Pins that are not planned for usage should

be left open without anything connected to them.

Pin Number Functionality HRNS057 Color Codes

1 Switched Power (Ignition) White

2 N/A No Connection

3 N/A Co Connection

4 Ground Black

5 Unswitched Power (Battery) Red

6 Input 1 Blue

7 N/A Green

8 N/A Brown

Table 1: 8-pin I/O Connector Functionality

The following figure shows the pin connections for the 8-pin connector.

Figure 4: 8 Pin Connector

The manufacturer part numbers for the parts needed to build the cables is noted in the following table.

Item Manufacturer Part Number

Connector Molex 43025-0800

Pins Molex 43030-0008 20-24 AWG

43030-0011 26-30 AWG

Crimp Tool Molex 63819-0000A

Table 2: Manufacturer Part Numbers to Build Cables

3.3 Installing the SIM (Subscriber Identity Module) Card

The SIM card is an integral part of any GSM terminal device. The SIM card may be installed by simply

inserting the SIM card in the SIM slot provided in the front of the device. With the SIM locking

mechanism on the right, the SIM card is inserted into the GPS-201/202 with the notch on the SIM card on

the left and going in first.