User manual

• Connect the ignition wire of the GPS-208 to an auxiliary power source, i.e. ignition.
• Device goes through a reset upon ignition on.
3.5 Optional Backup Battery
An optional 230 mAH backup battery is available for the GPS-208. The battery may need to be connected during the
installation process. The battery will need to be turned on via the power switch (see Section 3.0 for more information).
3.6 GPS-208 Installation
The enclosure for the GPS-208 includes molded anchor points for mounting as shown. Also, it is very important that the
top side of the GPS-208 (the side with the label) be facing towards the sky.
The battery switch must be turned on prior to connecting any auxiliary I/O devices. Failure to do so may
result in damage to the GPS-208 and/or the attached I/O device.
© CES Wireless Technologies Corp – 2011 Page 13 of 14
Figure 9: GPS-208 optional backup battery and
connector.
Figure 8: GPS-208 optional backup battery connected to the
main circuit board.
Figure 10: GPS-208 mounting anchors.