User manual

Figure 17: SMS Options

Destination: To configure the GPS-205 to send an SMS check Enable and then select the destination.

The destination can be an e-mail address of a mobile telephone number capable of receiving SMS. Select

the destination type and then enter the destination.

Individual SMS Options: For each SMS event to be configured select the Event from the drop down list

of events. Upon doing this a default message will be placed in the Message to Send text box. This

message can be accepted or edited as needed. Last, select if the Unit ID of the unit should be included in

the message. The Unit ID can be included in front of the text or after it. It is recommended that the Unit

ID be included in the SMS so that it is easy to determine what unit sent the message.

2.6 GPS-206 Options

The I/O, GeoStatus and SMS options for the GPS-206 are discussed in this section.

Note: These values should be selected with care as they will greatly effect the amount of

data used by the device. Be sure to configure the device to operate within your data plan.

2.6.1 GPS-206 I/O Options

The input and output options contains the configuration of the inputs of the GPS-206. The output on the

GPS-206 is always enabled.