User manual

NOTE: By default the output is in the high state.

Figure 18: GPS-206 I/O Options (both Inputs 1 and 2 are enabled)

2.6.1.1 Input 1

Input 1 can be disabled, set to send only on a high to low transition, set to only send on a low to high

transition, to send on both changes of state, to enable the advanced configuration of the input or to place a

call.

Figure 19: Input 1 Options

Each of these options are explained below.

2.6.1.1.1 Disabled

When the input is disabled no activity will occur when it’s state changes.

2.6.1.1.2 Send on High to Low State Change

When the input is enabled to send on high to low state change it will send a packet indicating this state

change. It will not send a packet when the state goes from low to high.

2.6.1.1.3 Send on Low to High State Change