User manual

When the input is enabled to send on low to high state change it will send a packet indicating this state

change. It will not send a packet when the state goes from high to low.

2.6.1.1.4 Send on Both

When the input is enabled to send on both it will send a packet indicating either state change.

2.6.1.1.5 Advanced Configuration

In addition to standard input state change reporting the GPS-206 can be programmed for additional

actions in the event of a state change. These actions are configured by selecting Advanced Configuration.

Note that the advanced configuration options are only available if GPS Position reporting is based upon a

minimum time or specific distance intervals (not both).

Figure 20: Advanced Input Configuration for Input 1

The GPS position reporting interval can be changed based upon the state of the input. By default this is

not enabled. To Enable it select the “Change GPS Report Interval on Input 1 Change”. The other fields

will then be enabled.

Select if the GPS position reporting interval should change when the input goes from low to high or from

high to low. Next, select the new time or distance reporting value. If using distance the selection can be

made in feet or meters.