User manual

Figure 21: Advanced Input Configuration - Enabled

2.6.1.1.3 Call

Input 1 on the GPS206 can be used to place a call to one pre-programmed number, to answer an incoming

call or to disconnect an active call. This functionality requires the use of a momentary switch on the input.

A device is available for this from CES (CES P/N zzzzzzzzz).

Call Functionality only works for Input 1.

When the input is configured for a call the Call Configuration area will be displayed for the call enabled

input.

Figure 22: Call Configuration for Input 1

Enter the phone number to call when the state of the input changes.

Call Operation Explained: The calling functionality works as follows when the momentary switch is

pressed. The GPS-206 must have an established GPRS connection for this functionality to work.

1. If the momentary switch on the input is pressed and no call is in progress it will dial the

programmed number.

2. If the momentary switch on the input is pressed and a call is in progress the GPS-206 will

disconnect (hang up) the call.

3. If the momentary switch on the input is pressed, no call is in progress and the GPS-206 is being

called the GPS-206 will answer the call.

The following “truth table” explains this in another manner.

No call in

progress

Call in progress Incoming call Action taken

True False False Initiate call to preprogrammed number

False True False Disconnect active call

True False True Answer incoming call

Table 3: GPS-206 Call Functionality Truth Table