User manual

Note: The use of SMS often requires the entry of a Gateway Number. Please contact your

cellular service provider to see if this is required and, if so, to get the value to be used.

Figure 35: PT-101 SMS Options

Destination: To configure the PT-101 to send an SMS check Enable and then select the destination. The

destination can be an e-mail address of a mobile telephone number capable of receiving SMS. Select the

destination type and then enter the destination.

Individual SMS Options: For each SMS event to be configured select the Event from the drop down list

of events. Upon doing this a default message will be placed in the Message to Send text box. This

message can be accepted or edited as needed. Last, select if the Unit ID of the unit should be included in

the message. The Unit ID can be included in front of the text or after it. It is recommended that the Unit

ID be included in the SMS so that it is easy to determine what unit sent the message.

2.8.4 PT-101 User Defined Button

The User Defined Button on the PT-101 can be configured to these packets: Input 7 High, Status with

Key Data, Current Position and to set the region for GeoStatus #23.