User manual

Figure 43: Sequential programming prompt.

Note that the Unit ID entered will be the first one programmed. To start the sequential programming click

OK. Otherwise, click Cancel. If OK was selected this prompt will be displayed

Figure 44: Sequential programming – Send Config button dialog.

The first Unit ID will be programmed when the Send Config button is clicked. Upon completion of the

programming of the unit there will be another prompt.

Figure 45: Programming complete – sequential programming

This prompt informs you that the unit was successfully programmed. The Unit ID programmed is noted

as well as the next Unit ID to be programmed. To continue programming disconnect the current unit and

make a note on the unit as to its Unit ID (we suggest placing a label on it with the Unit ID). Connect the

next unit and click on the Send Config button. If programming is complete no further action is required.

Begin Programming from Text File: This selection provides the capability to read Unit IDs from a

normal text file and use these Unit IDs to program a number of units. The text file should have one Unit

ID on each line with no other characters (letters, tabs, etc.).

After this option is selected the following prompt is displayed