User manual

1.0 Introduction

This manual contains instructions on how to configure the GPS-201, GPS-202 GPS-205, GPS-206, GPS-

208 and the PT-101 using DP-1000S version 7.5.

NOTE: DP-1000S Version 7.4.0.1 and up require the use of FleetControl Version 4.5 and

up. If you are using DP-1000S Version 7.4.0.1 and do not have FleetControl Version 4.5 or

greater contact CES Wireless Technologies before programming any devices.

2.0 DP-1000S Programming Software

The GPS-201, GPS-202, GPS-205, GPS-206, GPS-208 and PT-101 are programmed with the DP-1000S

programming software (DP-1000S).

GPS-205 Only: To program the GPS-205 you must use the power/serial interface cable (PRG-02). PRG-

02 is configured with a DB-9 serial connector, a heavy duty GPS-205 interface connector and leads for

power and ground. The power and ground leads should be connected to a power supply that supplies

power per the specifications in section 2.7. The DB-9 connector should be connected to an available serial

port on the computer. The GPS-205 interface connector connects to the GPS-205.

GPS-201, GPS-202, GPS-206: To program the GPS-201, GPS-202 or GPS-206 you must use the

power/serial interface cable (PRG-03). PRG-03 is configured with a DB-9 serial connector, a GPS-

201/GPS-202/GPS-206 interface connector and leads for power and ground. The power and ground leads

should be connected to a power supply that supplies power per the specifications in section 2.7. The DB-9

connector should be connected to an available serial port on the computer. The GPS-201/GPS-202/GPS-

206 interface connector connects to the GPS-201/GPS-202/GPS-206.

GPS-208 Only: To program the GPS-208 you must use the power/USB cable (PRG-05). The standard

size USB connector should be connected to an available USB port on the computer. You must also install

the device driver for the GPS-208. The device driver enables a virtual com port that will be used to

program the device. NOTE: If the device driver is not installed or if the GPS-208 is not connected to the

computer when you run the DP-1000S application an error will occur. Power should be applied to the

device using a standard 12V power supply.

PT-101 Only: To program the PT-101 you must use the power/USB interface cable (CABLE63). The

standard size USB connector should be connected to an available USB port on the computer. The mini

USB connector connects to the PT-101. You must also install the device driver for the PT-101. The

device driver enables a virtual com port that will be used to program the device. NOTE: If the device

driver is not installed or if the PT-101 is not connected to the computer when you run the DP-1000S

application an error will occur.

Note: To program the PT-101 the driver for it must be installed first. This driver creates a

virtual com port which is used to communicate with the PT-101. The driver can be obtained

from CES. Please contact Support for additional information.

All Devices: Once the DP-1000S software is installed and running, the select device form is displayed.

Select the desired device and click OK. The main DP-1000S window is now displayed. Please note that

you can switch devices while the application is running.