User manual

© CES Wireless Technologies Corp – 2010 Page 26 of 29
4.5.2.1 Unit Number
The Unit Number is a unique identifier that enables the software to determine which device is which. It is
very important that a unique number be programmed into each GPS-201. If using FleetLinc the Unit
Number will be provided by CES Wireless Technologies.
4.5.2.2 IP Address
The IP Address of the software (i.e. Power-Trak3 or FleetLinc) should be entered here. This is the IP
Address to which the GPS-207 will send packets to.
4.5.2.3 Port
The Port number used to communicate with the server should be entered here. This port should match the
configuration of the software on the server.
4.5.3 GPS Configuration
There are also three fields in the GPS Configuration. They are GPS Reporting Type, Stationary Interval
and In Motion Interval.
4.5.3.1 GPS Reporting Type
There are two selections for the GPS Reporting Type. They are Static Asset (refer to Section 4.5.3.4) and
In Motion (refer to Section 4.5.3.5).
4.5.3.2 Stationary Interval
The Stationary Interval is the interval the device should report at. For a Static Asset this is how often the
device should report its position. For an In Motion asset this is the interval that the GPS207 should report
its position when not moving.
4.5.3.3 In Motion Interval
The In Motion Interval only applies when the GPS Reporting Type is set to In Motion. This is the interval
at which the GPS207 will report while it is moving.
4.5.3.5 Static Asset
If the GPS207 is to be programmed to report its position at fixed time intervals regardless of movement
select Static Asset as the GPS Reporting Type.
The next step is to select the desired reporting interval from the available selections. The minimum value
is 120 minutes (2 hours) and the maximum is 10080 minutes (once per week).
Figure 43: Static Asset - Stationary Interval Selections