User manual

© CES Wireless Technologies Corp – 2010 Page 27 of 29
Note: the label at the bottom of the GPS207S form will display the estimated battery life based upon the
selected reporting interval.
Once the report interval is defined the configuration is ready to be sent to the GPS207.
4.5.3.5 In Motion
If the GPS207 is to be programmed to report using the In Motion GPS Reporting Type (report position at
one interval while stationary and at another interval if it is in motion) there are two additional parameters
– the stationary interval and the in motion interval.
The Stationary Interval has the following selections when using the In Motion type.
Figure 44: In Motion - Stationary Interval Selections
After selecting the stationary reporting interval the next step is to select the In Motion reporting interval.
These are the available selections
Figure 45: In Motion - In Motion Interval Selections
Note: the label at the bottom of the GPS207S form will display the estimated battery life based upon the
selected reporting intervals.
Once the report intervals are defined the configuration is ready to be sent to the GPS207.
4.5.4 Send Config
Once all of the parameters are defined the GPS207 can be programmed. This is done by clicking on the
Send Config button. As the GPS207 is programmed the progress bar to the right of the Send Config
button will display the progress.