Operating instructions

Fitting the Access Point
RF-NET Access Point 17
When fitting the Access Point, you must ensure the following
conditions:
 Make sure that the power supply and the power supply cable
can be plugged in.
 Make sure that the network cable can be plugged in.
 The Access Point must not be fitted on metallic surfaces.
 Always install the Access Point as far away from ground
potentials as possible to avoid interference with the radio
traffic.
 The Access Point may not be fitted outdoors.
The Access Point is supplied preassembled. To commission
your Access Point, you only have to fasten the wall mount at a
suitable position and push on the Access Point.
In addition, you require suitable fasteners for the Access Point.
The fasteners and the related tools required depend on the
material at the place of installation.
 Purchase suitable fasteners material from your specialized
dealer for fastening engineering.
CAUTION
Danger of injury by improper fitting.
 Ensure that the Access Point is only fitted by
appropriately trained skilled personnel.