Instruction Manual

11
Firing Pin Disassembly
Push in the rear end of firing pin using a suitable tool, below the level of the firing pin
stop, and press the firing pin stop approximately 2 mm down. Then cover the firing pin stop
with your thumb in order not to lose the spring-loaded firing pin, and with the other hand pull
the firing pin stop completely out of the slide. Be very careful at this stage of the disassembly
procedure, as the firing pin is spring-loaded and could fly out, getting lost, or even causing
injury.
Magazine Disassembly
To remove the magazine base, push on the base lock which sticks out through a hole
in the base and slide the base about 5 mm towards the front of the magazine (Fig. 9). Cover
the base with your thumb to prevent losing the magazine spring and with the other hand take
off the base from its guiding rails. Be careful during the disassembly as the spring could fly
out, or even cause an injury.
CAUTION:
No further disassembly of your pistol is recommended. Should your pistol require
adjustment or repair be sure the task is entrusted to a competent gunsmith!
Cleaning the Pistol
Clean the pistol
- Each time you use it
- If you get your pistol wet
- As soon as possible after shooting
- At least once a year in a temperate climate
- As often as once a month in a tropical climate, or other demanding environments