Instruction Manual
8
OPERATING INSTRUCTIONS
Ammunition
Use only factory-manufactured ammunition of appropriate caliber, which are in
compliance with CIP regulations (International Proof Commission for Firearms) or SAAMI
(Sporting Arms and Ammunition Manufacturers' Institute Inc. of the United States). The use
of other cartridges could damage the firearm or cause injury to the shooter.
Removing the Magazine
Grip the pistol in your right or left hand and depress the magazine catch located by the
thumb or middle finger (Fig. 2). The magazine disengages and falls out of the frame. This
pistol model is equipped with the user type magazine catch which can be reversed by
gunsmith for the right or left hand operation.
Loading the Magazine
With the open end uppermost, grasp the magazine in one hand. Place a cartridge on
the magazine follower. Press the cartridge down and back until it touches the rear edge of
the magazine. Place the next cartridge on top of the previous cartridge and press down and
back as previously described. We recommend that when some cartridges are loaded in the
magazine, depress them slightly with the thumb of the hand which holds the magazine.
The number of cartridges can be checked through the inspection holes in the sides of
the magazine. Do not try to exceed the magazine capacity - doing so can cause a feeding
failure.
Loading of the Pistol
ALWAYS MAKE SURE THE PISTOL IS POINTED IN A SAFE DIRECTION WHEN LOADING!
Insert a loaded magazine and ensure that it has engaged the magazine catch properly.
Hold the pistol by the grip with one hand, and with the thumb and index finger grasp the
serrated finger grips on both sides of the slide. Retract the slide to the stop and allow it to
snap forward (Fig. 3). This procedure cocks the hammer and inserts a cartridge into the
chamber. The pistol is now ready to fire. If you do not intend to fire immediately ensure the
pistol safety by one of the methods mentioned in the section: Engaging the Safety Mode.
Reloading While Shooting
When the last cartridge has been fired the slide will stay to the rear. Remove the empty
magazine and replace it with a loaded one. Depress with the thumb the slide stop with the
shooting hand (Fig. 4), or retract the slide with the other hand and allow it to snap forward
(Fig. 3). The pistol is again loaded and ready to fire.