Instruction Manual

!8
Comments:
Precocked SA (Single Action)
Precocked single action trigger mechanism. Before firing, the firing mechanism with
striker is partially precocked. When the trigger is pulled, it is further cocked and finally
released. After each firing, the trigger must be paritally released.
Safety Features
Trigger Guard
Prevents unintentional pressing of the trigger, for example when the pistol is dropped.
Fall safety
Minimizes the risk of unwanted firing during improper handling, especially when a
loaded pistol falls and there is a risk of firing due to inertia of the firing pin.
Trigger safety
Prevents unwanted movement of the trigger. Unless the trigger safety is deactivated,
the trigger cannot be pulled, thus the pistol cannot be fired.
Firing pin blocking
Prevents the movement of the firing pin when the trigger is not pulled.
OPERATING INSTRUCTIONS
Ammunition
Always use ammunition in an allowable production design which is in compliance with
standards applicable for ammunition manufacturers and is approved by the CIP (Permanent
International Commission for Firearms Testing) or SAAMI (Sporting Arms and Ammunition
Manufacturers' Institute Inc. of the United States). The use of other cartridges could damage
the handgun or cause injury to the shooter. When using factory-made ammunition with
standard speed, the use of firearms produced by Česká zbrojovka a.s. is safe. Check the
ammunition you are going to use to make sure that it corresponds to the caliber of your
firearm. Commercially produced ammunition is clearly marked with the caliber on the bottom
or around the bottom of each cartridge case.
Removal of the Magazine
The pistol is equipped with an ambidextrous magazine catch. Grip the pistol in your
right (left) hand and by the thumb (middle finger) depress the magazine catch (Fig. 2). The
magazine disengages and falls out of the frame.
Magazine Loading
With the open end uppermost, grasp the magazine in one hand. Place a cartridge on
the magazine follower. Press the cartridge down and back until it touches the rear flat edge
of the magazine (Fig. 3). Place the next cartridge on top of the previous cartridge and press