Instruction Manual

down and back. We recommend that when some cartridges are already loaded in the

magazine, depress them slightly with the thumb of the hand which holds the magazine.

The number of cartridges can be checked through the inspection holes. Do not try to

exceed the magazine capacity - doing so can cause a feeding failure.

Pistol Loading

ALWAYS MAKE SURE THE PISTOL IS POINTED IN A SAFE DIRECTION WHEN LOADING!

Insert a loaded magazine and ensure that it has engaged the magazine catch.

Hold the pistol by the grip with one hand, and with the thumb and index finger grasp the

serrated finger grips on both sides of the slide. Retract the slide to the stop and allow it to

snap forward (Fig. 4). This procedure precocks the trigger and firing mechanism and inserts

a cartridge into the chamber. The pistol is now ready to fire.

Reloading During Shooting

When the last cartridge has been fired the slide will stay to the rear. Remove the

emptied magazine and replace it with a loaded one. Thumb down the slide stop with the

shooting hand (Fig. 5), or with the other hand draw back the slide and allow it to snap

forward. The pistol is again loaded and ready to fire.

Unloading the Pistol

ALWAYS MAKE SURE THE PISTOL IS POINTED IN A SAFE DIRECTION!

- Remove the magazine

- Draw back the slide and verify the last cartridge has been extracted from the

chamber and ejected

- Let the slide snap fully forward

- Depress the trigger (dry fire)

Sight Adjustment

The pistol sights were sighted in at the manufacturing plant at a distance of 15 m so

that the mean point of impact approximately conforms to the point of aim. Windage

correction can be carried out by the drifting of the rear sight in the dovetail and then secured

in its position by screw. Elevation correction is carried out by exchanging the front sight for

higher or lower sizes and by securing with a screw.

Changing the Back Strap Inserts

Each pistol is supplied with a set of changeable back strap inserts, which enables the

rear part of the grip to be adjusted according to the individual needs of the user. In order to

change the back strap inserts it is necessary to remove the back strap pin (Fig. 6).