Owner`s manual

9
Installation
CHARGING THE TRANSMITTER
Prior to operating the Orbiter for the fi rst time, please allow a
couple hours to charge the transmitter. The Orbiter transmitter
charges like a cell phone.
1. Plug charger into power outlet.
2. Connect charger to transmitter base.
3. Transmitter LED will illuminate when charging.
Green blinking – charging
Green steady – charged
4. Please allow a couple hours for full charge.
Using the transmitter charger
CAUTION
Do not leave the transmitter connected to the charger
for more than a week. It may cause the degradation of
battery performance, such as a shortening of battery life.
When charging the battery, do not use any battery
charger not specifi ed by Cetacea Sound.
CAUTION
Observe the following safe operational temperature ranges:
Charge 0 °C / 32 °F to 45 °C / 113 °F
Storage (less than 90 days) -20 °C / -4 °F to 35 °C / 95 °F
Diagrams
STATUS INDICATOR LED
On / mute – green steady
Charging – green blinking
Charged – green steady
Low battery – green blinking
CHARGER CONNECTOR
C
C
IMPORTANT
The Orbiter will not start up if the battery is insuffi ciently
charged. Charge it for at least an hour prior to operation.