User's Manual

conjunction with any other antenna or transmitter. This product has
been shown to be capable of compliance for localized specific
absorption rate (SAR) for uncontrolled environment/general
population exposure limits specified in ANSI/IEEE Std. C95.1-1992
and had been tested in accordance with the measurement procedures
specified in FCC/OET Bulletin 65 Supplement C (2001) and IEEE 1528.
For Base:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator&
your body.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
ISEDC Warning
This device complies with Innovation, Science, and Economic
Development Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device.
The device is compliance with RF exposure guidelines, users can
obtain Canadian information on RF exposure and compliance.
ISEDC Specific Absorption Rate (SAR) information
For Handset
SAR tests are conducted using standard operating positions accepted
by the ISEDC with device transmitting at its highest certified power
level in all tested frequency bands, although the SAR is determined at
the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. Before a new
model device is an available for sale to the public, it must be tested
and certified to the ISEDC that it does not exceed the exposure limit
established by the ISEDC, tests for each device are performed in
positions and locations as required by the ISEDC.