Installation Instructions

F A CEPLATE
To install a faceplate, simply r emo v e the plas tic
overly (no tools required) and insert the paper
faceplate over the buttons . Then replace the
plastic o v erla y .
Oper ation
VOLUME C ONTR OL
Ringer volume control: The ringer volume is
controlled via the “ Volume +/–” k e y .
There are five volume l e v els . When you have
r eached the maximum or minimum sound l e v el
there will be a warning beep .
HANDSET VOLUME C ONTR OLS
The handset volume control increases the volume
of the handset .
When the handset is off-hook or the Speaker key
engaged on speakerphones, press the V olume
Control keys to increase or decrease the v olume .
The handset volume control is a 5-step operation .
All models are hearing aid compatible .
ON - HO OK AND OFF - HO OK / PICK - UP
AND HANG - UP
Base unit: To get a dial tone with off-hook s t atus,
press a line key or the Speaker key to pick up with
speak er . To hang up or go on-hook, press a line
or the Speaker key again to hang-up .
Handset: Press ON/OFF key in the handset
faceplate to pickup or hang-up .
HOLD
Base unit and handset: Controls the “local hol d”
function . Each press of the [Hold] key toggles the
l oc al hold mode On or Off . An LED indicator l oc at ed
above the [Hold] key displays the on-hold status .
MUTE
The Mute key toggles the microphone Mut e
function On and Off . The LED indicator above
the [Mute] key displays the On/Off status of the
Mute function . When Mute is on, the handset and
hands-free microphone audio are turned off . Y ou
will be able to hear the party at the other end of
your call, but they will not be able to hear y ou .
REDIAL
Redials the last-dialed telephone number, up t o
24 digits . After 30 minutes, the redialed number
will automatically be r emo v ed (for security and
priv acy) .
MES SA GE
1 . The hidden 3-position switch mark ed
TYPE LR1 LR2 configures the message-
waiting lamp .
2 . For most applications the TYPE position
will work . This is the factory def ault
setting . Always try the TYPE position first:
If the message lamp blinks when a
message is in the mailbox, this c onfirms
that TYPE is the correct setting .
3 . For some PBX systems that provide
r e v er se polarity message signaling, it may
be necessary to move the switch to either
LR1 or LR2 . The correct position of the
switch will cause the message lamp to be
on continuously when a message is in the
mailbox .
PA G E
CALL THE HANDSET
Press the base unit’s Page key to call the handset
and the handset’s Message and On/Off indicat or
lights flash . Press the Page key again (or any
key in the handset or place the handset into the
cradle) to end the page .
REGISTERING A HANDSET
Auto-Sync Handset R egistr ation
Place the handset into the base unit cradle and
make sure the charging l eads make c ontact . The