User's Manual

15
----Set E103-IP’s IP address in the IP Address;
----Set netmask in the Netmask field;
----Set router IP address in the Gateway;
----DNS Domain:
----Set local DNS server in the Preferred DNS and the Alternate DNS。
Configure to dynamic obtain IP
----Enable DHCP;
If there is DHCP server in your local network, E103IP will automatically obtain
WAN port network information from your DHCP server.
Configure PPPoE:
----Enable PPPoE
----PPPoE server: Enter “ANY” if no specified from your ITSP.
----Enter PPPoE username and password in the username and password.
E103IP will automatically obtain WAN port network information from your ITSP
if PPPoE setting and the setup are correct.
Notice: If user accesses the IP phone through WAN port. She/he should use the
new IP address to access the IP phone when the WAN port address was
changed.
3.3.2 LAN Config
LAN IP /Netmask: Set the IP and Netmask for the LAN
DHCP Server: Enable DHCP service in LAN port; after user changed LAN IP,
phone will automatically modify DHCP Lease Table and save the configure
according to IP and Netmask, DHCP server configure won’t take effect unless you
reboot the device.
NAT: Enable NAT.
Bridge Mode: Enable this option to switch to bridge mode. IP phone won’t
assign IP for its LAN port in bridge mode and its LAN and WAN port will be in the
same network. (This setting won’t take effect unless you save the config and
reboot the device)