User's Manual

8
Redial Dialing Redial the number of last time
Volume + Call Increase the volume
Volume -
Call Reduce the volume
FNC Off-Hook Quickly cut off the current line and off-hook again.
Dialing “1”
1
On-Hook Long pressing can pick up the message
2
Dialing “2”
3 Dialing “3”
4
Dialing “4”
5
Dialing “5”
6 Dialing “6”
7
Dialing “7”
8 Dialing “8”
9
Dialing “9”
0
Dialing “0”
Dialing “*”
*
On-Hook Long pressing for 3 seconds entering into the
registration status of the handset
# Dialing It can be regarded as the first number being dialed out or
the end mark for ending number.
2.2.1 Store numbers
Press “STORE” key to enter into the setting state of storing keys, and input
storing number, then press the corresponding storing key to store the numbers.
2.2.2 Voice Control
Pressing “VOL+” to increase the volume, and press “VOL-” to decrease the
volume.
2.2.3 Hold Function
It is used for holding the current line or forwarding to other handset, for
example:
When you use the #1 handset and want to use the #2 in a call, now you need
to hold the #1 handset then pick up the #2 handset.
If line1/2 is in the conversation, press down “line1/2” key or “hold” key, may
hold the current conversation.
2.2.4 Register handset
The handset registers to the base have two ways: Manual registration and
automatic registration.
Manual registration: Under On-Hook status, pressing the “Locate” key on the
base unit for three seconds to enable the handset register mode, and the Charge
indicator light flashes at the same time; then press “*”key for three seconds to
enable the handset register mode, then ON/OFF indicator light on the handset, and
will give the prompt tone for successful registration.
Automatic registration: place the handset in the plane, the “charge” instruction