User Manual

message when "--CAL--" is displayed. Wait until the standard weight
value is displayed. ", place the weight of the "standard weight value" that
shines on the plate, display "---" waiting state, wait a moment, display
"standard weight value", take the weight, the display becomes "---" wait
Status, wait, "0 or 0.0 or 0.00" is displayed and the calibration is
completed. If the weighing after calibration is still inaccurate, repeat the
calibration several times as described above.
(3)Calibration Video
We have record a video how to calibrate of 5000g,0.01g balance for your
reference,please kindly check it.
Calibration Video
：
Scan code (1’30’’ in the video)
Friendly remind: Please kindly make sure the balance steadily. Place the
balance on a smooth and steady table and adjust balance through
tightening four black screws at the button of the balance.
3. Weighing
(1) After power-on stabilization or calibration, display weighing mode 0
or 0.0 or 0.00”.
(2) Set the weight on the weighing pan, which shows the weight of the
item.
4. Tare
(1) Place the container on the weighing pan and the balance shows the
quality of the container.
(2) After pressing the "TARE" TARE key, "0.0 or 0.00 or 0.000" is
displayed, which means that it has been tared.
(3) Placed in the container, that shows the quality of the object.
5. Balance Counting Operation
(1) Enter to set a single count object average state:
Place the weighing container on the weighing pan and use the container.
If you do not need to hold the container, press the “TARE” key to display
“0 or 0.0 or 0.00”. Then press the “PCS count” key to display “10”. In the
lower right corner, "g to PCS" is displayed, and then 10 objects to be
CGOLDENWALL® HZ Electronic balance
Brand Store: https://www.amazon.com/stores/node/16348280011