Owner`s manual

2014 Glacier Bay 2770 Owners Manual
Chapter 7: MAINTENANCE AND SERVICE
7.1 OVERVIEW
This chapter provides basic information for maintaining the original appearance and dependable
performance of your Glacier Bay. Although your vessel is constructed of the finest materials available, the
harsh saltwater environment and other factors, including geography and usage rate, will affect its finish and
function over time. It is imperative that you understand how to care for your catamaran properly. Some
simple steps will help maintain its aesthetics, value, and reliability.
7.2 GELCOAT MAINTENANCE
Gelcoat is a thin layer of resin mixed with colored pigments, which provides the exterior finish on your
boat. Gelcoat provides a smooth durable surface to protect the fiberglass construction of the hull, but is still
flexible enough to absorb the pressure exerted upon it during operation. Mainly used for cosmetics, gelcoat
is relatively simple to maintain. However, without routine cleaning, it will discolor due to the microscopic
pores in the surface. Following are some instructions for maintaining your gelcoat.
7.2.1 Cleaning
After each trip on the water, or after trailering long distances, you should clean the boat immediately.
Washing the boat with mild detergents, such as dishwashing soaps, and fresh water will help eliminate
build up or discoloration resulting from environmental pollutants. Use a sponge or other soft cleaning
device on the smooth exterior surfaces of the hull and deck. A soft brush can be used when cleaning
nonskid portions of the deck. Make sure to rinse the boat thoroughly after cleaning.
!
!
!
!
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Using strong or caustic cleaning agents, such as bleach, citrus based cleaners, or one containing
ammonia, will damage the appearance and strength of your gelcoat.
7.2.2 Waxing
Similar to automotive finishes, gelcoat will begin to fade over an extended period of time. Constant
exposure to environmental pollutants and this aging process will result in a loss of shine. However, it is
possible to restore the original luster and color using a polishing compound (mild abrasive) or a rubbing
compound (harsh abrasive). Each will remove scratches, discoloration, and help restore weathered gelcoat
surfaces but you should select what to use based on the severity of the problem. Use the following steps to
restore the finish of your gelcoat.
1. Clean the affected area completely using a mild detergent.
2. Gently wet sand the affected area using a fine sandpaper (600 grit) to remove any stains. Use
plenty of water and always sand in one direction using curved strokes. Sanding in alternating directions
could result in damage to the finish.
3. Apply polishing compound to a buffing pad and follow the manufacturers instructions. If you
apply the compound mechanically, we recommend a lamb wool buffing pad and a electric buffer capable of
1750 to 1800 RPM.
4. When you have completely buffed the area, wash away any remaining compound using clean
water.
After thoroughly cleaning the surface, wax the affected area. This will help restore the finish and provide a
seal against future discoloration.
Page 7-37