Instruction Manual

Issue 4 19/8/2021 7
Take off the nozzle Lift off water tank Turn over, unscrew the cap
4. Fill from the tap or distilled water container to the top of upturned tank or as
much as required
5. Replace filler cap/filter assembly.
Fill (tap or Jug) Fasten the cap Fit tank to base as align marks
Align marks
6. Turn the tank over and wipe away any spilt water, carefully fit the tank onto the
base, taking care to align correctly noting the alignment marks on the base unit
and tank.
7. Refit mist cover (1)
Note: Make sure the base unit is installed in the exact place and position it is
to be used BEFORE fitting the water tank so as not to unnecessarily move
the whole unit when the water reservoir has filled from the water tank as this
could cause spillage!
8. Plug in to a 220-240V~50/60Hz, wall socket, and switch on with units main
power switch (5)