Assembly Instructions

16
Customer Helpline 0343 515 1906
Setting the Cutting Heights
Operating Instructions & Tips
IMPORTANT! Set the cutting height only when the motor is switched off and the power cable has
been disconnected.
The cutting height is adjusted as shown in Figs. 4a and 4b. To do this, turn the hub cap clockwise
to release the bolt (Fig. 4a) and remove the hub cap with the bolt and wheel. The wheels can now
be tted in position 1, 2 or 3 to suit the required cutting height. Fit all four wheels at the same height
so that the cutting blade rotates parallel to the lawn.
Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners
are damaged. To prevent any imbalance, replace blunt and/or damaged blades. To carry out this
check, rst switch off the motor and pull out the power plug.
Position Cutting height
1 20 mm
2 40 mm
3 60 mm
4a 4b
1
3
2