Assembly Instructions

21
Customer Helpline 0343 515 1906
General Troubleshooting
Troubleshooting
The following table provides solutions to common problems encountered with the mower.
Fault Possible Cause Solution
Mower does not start No power at mains socket Check the fuse, switch,
socket, cable, wire and have
any repairs carried out by a
qualied electrician
Defective on/off switch Repair by a qualied technician
required
Worn carbon brushes
Defective motor
Grass too long Set at a higher cut setting.
Lift the front wheels slightly by
pressing down on the handle
bar.
Motor stops Blade is blocked Disconnect from mains and
remove blockage
Untidy nish, motor labours Cut height too low Set a higher cut height
Blade blunt Sharpen or replace the blade
Blade area blocked Remove blockage
Blade assembled incorrectly Install the blade correctly
Blade fails to turn Blade blocked by grass Remove blockage
Blade bolt loose Tighten the blade bolt
Strange noises, rattling or
vibrations
Blade bolt loose Tighten the blade bolt
Blade damaged Replace the blade