Instruction Manual

1716
Customer Helpline 01904 727508
www.coreservice.co.uk
Customer Helpline 01904 727508
www.coreservice.co.uk
Maintenance and Repair
Maintenance and Repair
WARNING! Always switch the product off, unplug from the power socket and let the product cool
down before performing inspection, maintenance and cleaning work!
- After every use wipe the machine with a slight damp cloth. Do not clean the machine using a high-
pressure water jet.
- Clean the high-pressure jet nozzle.
The pressure washer is equipped with a water lter to protect the pump. If the lter is not kept clean,
the water ow to the machine will be restricted and the pump may be damaged.
To clean water lter, remove inlet adapter and get the lter out.
− Rinse lter until it is free of debris and blockage.
− Replace the lter and inlet adapter.
Clearing of the Lime scale
From periods of time, water lime scale may build up on your lance outlet, use the nozzle cleaning pin
to clean this away.
Frost can damage your pressure washer that has not been completely emptied of water. The machine
should be stored in a frost free room. Do not kink high pressure hose.
Storing
Storage and Transportation
Troubleshooting
General Troubleshooting
WARNING!
- Only perform the steps described within these instructions! All further inspection, maintenance and
repair work must be performed by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
- Always turn off the machine and remove the plug before making any adjustment.
Problem
Possible cause Solution
1. No power - Check the plug socket, cable,
line and plug.
- Any of the parts are defective,
such as On/Off switch / motor
etc.
- Connect to mains socket.
- Check by a specialist
electrician.
2. The high pressure washer
operates intermittently.
- Power cable is damaged.
- Internal loose electrical
connection.
- On/Off switch defective (please
contact service agent).
Check by a specialist electrician.
3. No or only little pressure is
built up
- Check if there is any air in the
system.
- Check all inlet pipes leading to
the pump for leaks or the hose is
blocked or there is a kink in the
pipe
- Check the setting on the hand-
held spray gun.
- If so, please ventilate the
machine! Run the machine
without the highpressure
hose connected until water
starts leaking without bubbles.
Reattach the high-pressure
hose.
- Check by a specialist
electrician
- Follow the Operation part
again.
4. Pressure varieties - Check the high pressure jet
nozzle
- Check the water inlet pressure.
If blocked, clean it with pin.
5. Machine is leaking. Machine is leaking Please contact the service
agent.
6.Engine is running but no
pressure is build up
You might have air locked in the
hose.
Turn off machine, disconnect
hose, run water through and
connect again. If the problem
continues --then please contact
the customer helpline.