Installation Manual

CONNECT THE HOIST RELEASE

NEED TEXT

ART NOT

FINAL NEED

REF

INSTALLATION

WIRING THE CABLE TENSION MONITOR (CONT.)

4. Locate the black 4-wire data cable with a green (color needs to be conﬁrmed) 5 pin

connector at one end.

5. Locate the black 2-wire Power Cable with a green (color is tbd) 2 pin connector at

one end.

6. Locate the grey 4-wire encoder cable attached to the operator.

7. Pull the encoder cable into the junction box through the cord grip (on back side of

junction box - include diagram).

8. Route the encoder cable, power cable, data cable, and cable tension monitor wire

through the conduit to the wall controller.

Keep the connector end at the powerhead. Route the loose end down to the door

controller.

Use the slots in the lower surface of the junction box along with cable ties as strain

reliefs for the cables.

NOTE: All wires will ﬁt in a single 1/2" conduit , but two 1/2" conduits can be used if

desired.

9. Plug the 5-pin and 2-pin connectors into the inverter board (picture of inverter

board is needed as reference).

INPUT VOLTAGE SELECTION SWITCH

NOTE: All units are set for 240 volt AC input. If input voltage is 120VAC

then remove violator label and toggle switch to 120V position. (NEED

REFERENCE).

Put violator labels back on after selection.