Installation Manual

22
Step Display Actions
1
Quick Setup
Use
Up and Down
Quick Setup
Jog
Door to Center
Quick Setup
Press Enter
When Finished
Use the UP and DOWN Buttons to move the door to
near the center of travel.
Note: The door may travel in the opposite direction
of the button pressed. This is okay and is corrected
in a later step.
Press ENTER when finished.
2
Quick Setup
Press and Hold
Up to Open Door
Quick Setup
Check Door
Direction
Quick Setup
Door Will Stop
Automatically
Press and hold the UP Button until the door stops
automatically.
3
Quick Setup
Did Door
Open?
Quick Setup
Press Up
For Yes
Quick Setup
Press Down
For No
When the door has stopped, follow the on screen
prompts to confirm the door’s travel direction.
(If Down For No was pressed because the door did
not move up (open), two of the motor wires must
be swapped to change motor direction. Swap the U
and V wires at the motor output terminal block.)*
Repeat the process of learning limits.
4
Open Limit
Use
Up and Down
Open Limit
Jog Door To
Open Limit
Open Limit
Press Enter
When Finished
Using the UP Button, move the door to the desired
fully open position.
Press Enter to store.
5
Close Limit
Use
Up and Down
Close Limit
Jog Door To
Open Limit
Close Limit
Press Enter
When Finished
Then, using the DOWN Button, move the door to the
desired fully closed position.
Press Enter to store.
PROGRAMMING
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect electric power BEFORE performing ANY adjustments or maintenance.
• ALL maintenance MUST be performed by a trained door systems technician.
• Please wait several seconds for capacitors to discharge and for display to go out.
STILL NEED SCREENS FOR INITIAL COMMISSIONING PROCESS
INITIAL COMMISSIONING