Installation Manual

23
MENUS
To enter program mode from the front panel buttons, press and hold Stop, Open and Close
together for 3 seconds. The screen will display "Control By Buttons". The Stop button
functions as Enter and the Open and Close buttons function as Up and Down. If no button
is pressed for 30 seconds the controller will exit this programming mode.
The internal Menu/Enter, Up, and Down buttons are always active for programming.
The main menu is displayed as graphic icons on the display. The sub menus below the
main menu are "text listed" menus.
The sub menus below the main menu are “text listed” menus.
• Menus are navigated using the UP, DOWN and MENU/ENTER buttons.
• A menu or submenu is entered by a short press of the MENU/ENTER button.
• A short press of the MENU/ENTER Button while inside of a submenu will confirm a
selection.
• A long press of the MENU/ENTER Button will exit the submenu or menu.
NOTE: If a setting is changed, and then a long press of MENU/ENTER is made, the setting
will NOT be saved.
NOTE: If any menu except System Status is accessed, door operation is halted until the
menu is exited.
PROGRAMMING
Menu
Enter
Menu
Enter
Menu
Enter
Menu
Enter
Menu
Enter
Menu
Enter
NOTE: Press and hold Menu/Enter
to back up one menu level at a time
Idle
Screen
System Status System Status
Overview
LMEP
Position
Radio
Operating Mode
Limit Setup
System Cong
Radio
Learn
Erase Sec. +2.0
Erase myQ
Prole Selection
Operating Mode
Freq. Proles
Optr. Proles
Limit Setup
Quick Setup
Closed Limits
Pre-Closed
System Cong
Timers
Outputs
Inputs
INSTALLER PASSCODE
224
NEW MENU TREE
TO COME