Installation Manual

PROGRAMMING / FREQUENCY PROFILES

The controller contains three preconﬁgured frequency proﬁles that

control the motor speed, as well as the acceleration and deceleration

ramps. These proﬁles cannot be manually altered. If accelerations or

decelerations are too high, reduce the frequency proﬁle to a lower

setting.

Medium is the default setting for all proﬁles.

FREQUENCY (SPEED) PROFILE SETTINGS

DIRECTION LOW MEDIUM HIGH

Open 30 60 90

Close 30 40 60

To Change the frequency proﬁle setting, select Operating Modes –

Freq. Proﬁles.

Freq. Profiles

Low

Medium

High

A checkbox indicates which frequency proﬁle is currently active.

Choose either the Low, Medium or High setting.

The screen will display Loading Frequency Proﬁle and then return to

the top menu.

Frequency

Profile

PROGRAMMING

SETTING THE OPEN MID-STOP

This operator allows for the programming of a single mid-stop door

position.

To set the open mid-stop position:

1. In Programming Mode, go to Door Postion => Open Mid-Stop or

Close Mid-Stop.

2. Use the Up/Down buttons to move the door to the desired

position.

3. Save = Enter

To erase the mid-stop, select Erase Open Mid-Stop or Erase Close-

Mid Stop option. Save=Enter.

NOTE: Restoring defaults or resetting limits will erase the mid-stop

position.

THIS SECTION REQUIES NEW

PROFILE DETAILS FROM TEAM