Installation Manual
7
OVERVIEW (CONT.)
To prevent possible SERIOUS INJURY or DEATH:
• DO NOT connect electric power until instructed to do so.
• If the door lock needs to remain functional, install an interlock
switch.
• ALWAYS call an Authorized Service Technician if door binds,
sticks, or is out of balance. An unbalanced door may NOT
reverse when required.
• NEVER try to loosen, move, or adjust doors, door springs,
cable, pulleys, brackets, or their hardware. ALL of which are
under EXTREME tension and can cause SERIOUS PERSONAL
INJURY.
• Disable ALL locks and remove ALL ropes connected to door
BEFORE installing and operating door operator to avoid
entanglement.
• Fasten the operator SECURELY to structural supports of the
building.
• Concrete anchors MUST be used in installing ANY brackets.
ART NOT
FINAL
PLEASE PROVIDE
CONTENT AND
REFERENCE
Encoder
Junction box
Hoist chain
Step Drill Bit
(must accommodate
5/16" and 3/4" gradations)
Pliers
Wire Cutters
Wire Strippers
Claw Hammer
Flat Head Screwdriver
Phillips Screwdriver
Level
3/4" Open End Wrench
1/4" and 3/4" Sockets
and Wrench with
6" Extension
Drill
Tape Measure
Stepladder
Pencil
Needle Nose Pliers
5/32", 3/16", 5/16"
and 3/4" Drill Bits
TOOLS NEEDED
WHAT IS THIS
SECOND IMAGE
INTENDED TO
CONVEY?