User Manual

2
INSTALLATION
1. Choose a mounting location suitable for
your application such as a wall, flat
surface, or a pedestal with a 3" x 3"
mounting pattern (LiftMaster gooseneck
pedestal post models PED42 or PED64).
2. Unlock and remove the faceplate from
the mounting plate.
3. Mount the mounting plate to the desired
surface and secure with 1/4" screws or
bolts (not provided).
4. Remove the battery cover using a
Phillips screw driver. Install the battery
(provided) and re-install inner cover.
5. Reattach the faceplate to the mounting
plate and lock with the key.
BASIC PROGRAMMING
The Wireless Commercial Keypad must be put into programming mode prior to any of the programming steps
below unless otherwise indicated. The keypad backlight will remain on if the product is in programming mode.
While in programming mode, if an invalid code is entered, an error tone will sound, but the keypad will remain in
programming mode. After 60 seconds of inactivity, the keypad will exit the programming mode. The 6-digit
Master Code is used to prevent unauthorized access to the system. A Master Code is required (factory default
code: 888888) to operate the Wireless Commercial Keypad. It is highly recommended to change and record your
unique Master Code.
Set Master Code
Program a PIN
To prevent possible SERIOUS INJURY or DEATH from a moving gate or door:
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with
remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions
to door travel.
• ALWAYS keep gate or door in sight until completely closed. NEVER permit anyone to cross path of moving
gate or door.
Programming Step Keystroke Combination Indicator
1. Enter program mode
*
(Master Code) #
Long tone
2. Update Master Code 09 # (New 6-digit Code) # (New 6-digit Code) # Long tone
3. Exit Program Mode
* *
#
Keypad backlight will turn off
Programming Step Keystroke Combination Indicator
1. Enter program mode
*
(Master Code) #
Long tone
2. Set new pin 01 # (New 4-digit PIN) # (new 4-digit PIN) # Long tone
3. Exit Program Mode
* *
#
Keypad backlight will turn off
NOTE: An error tone will sound if the maximum number of PINs is exceeded or if user tries to program a PIN
already programmed in the memory.
Battery
Mounting plate
Faceplate
Battery Cover