User Manual

TROUBLESHOOTING

BATTERY

The 9V Lithium battery should

produce power for up to 5 years.

To replace the battery:

1. Unlock and remove the faceplate

from the mounting plate.

2. Remove the battery cover using a

Phillips screw driver.

3. Remove the old battery and install

new 9V Lithium battery. Re-install

inner cover.

4. Reattach the faceplate to the

mounting plate and lock with the

key.

5. Dispose of old battery properly.

ONE YEAR LIMITED WARRANTY

LiftMaster warrants to the first consumer purchaser of this product that it is free from defect in materials and/or

workmanship for a period of 1 year from the date of purchase.

NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are

prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

LiftMaster.com

1-800-528-2806

To prevent possible SERIOUS INJURY or DEATH:

• NEVER allow small children near batteries.

• If battery is swallowed, immediately notify doctor.

To reduce risk of fire, explosion or chemical burn:

• Replace ONLY with 9V Lithium battery.

• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.

Battery

Mounting plate

Faceplate

Battery Cover

Symptom: The keypad will not program to the operator.

Cause: The keypad is programmed to the wrong frequency and encryption.

Solution: Program the keypad to match the operator's frequency and encryption (see page 3).

Symptom: The backlight and tone on the keypad no longer work.

Cause: Battery may be dead.

Solution: Replace battery with 9V Lithium battery.

REVIEW COPY