User's Manual

To prevent possible SERIOUS INJURY or

DEATH from a moving gate or garage door:

• ALWAYS keep remote controls out of

reach of children. NEVER permit children

to operate, or play with remote control

transmitters.

• Activate gate or door ONLY when it can be

seen clearly, is properly adjusted, and

there are no obstructions to door travel.

• ALWAYS keep gate or garage door in sight

until completely closed. NEVER permit

anyone to cross path of moving gate or

door.

Introduction

This product is for use with model 850LM and

860LM receiver. Depending on the receiver

channel, you may program up to 20 or 50

remote control dip switch configurations to your

receiver. To exceed the 20/50 limit, match the

dip switches in the new remote control to the

dip switches in an existing remote control.

MODEL 811LM

Set the Dip Switches

1 Slide the cover open to access the dip

switches in the remote control.

2 Use a pen or screwdriver to slide the dip

switches to any position you want (ON or

OFF).

1 Press and release the Learn button for the

selected channel on the receiver. The

corresponding LED will glow steadily for 30

seconds.

2 Within 30 seconds press and hold the button

on the remote control that you wish to

program to the receiver.

3 Release the remote control button when the

LED on the receiver blinks, then turns off.

Programming is complete.

Repeat the steps above for each remote control

you would like to program.

Programming

Learn Buttons

PAGE 1
MODEL 811LM Introduction This product is for use with model 850LM and 860LM receiver. Depending on the receiver channel, you may program up to 20 or 50 remote control dip switch configurations to your receiver. To exceed the 20/50 limit, match the dip switches in the new remote control to the dip switches in an existing remote control. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: • ALWAYS keep remote controls out of reach of children.
PAGE 2
The Remote Control Battery The 3 volt battery should produce power for 1 year. Dispose of old batteries properly. To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or remote control are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.